FERRET Receiver
DS-FERRET-1
Part No
Description
FERRET-4R1 Receiver module 6-24V version 433MHz
FERRET-8R1 Receiver module 6-24V version 868MHz
FERRET-9R1 Receiver module 12V version 918MHz
Ordering Information
Part No
Description
FERRET-PSU 110—230Vac to 12V Power Supply for FERRET RX
FERRET Receiver 6-24Vdc
110—230Vac Power Supply Module
Intended Use
Ferret Receiver intended use is to provide a switching Changeover contact to control an
appliance via RF control. The essential performance of the Ferret Receiver is to receive
signals from an RF Transmitter for control of the Load circuit.
Safety Warning using 110—230Vac Version
• Installation Failure to follow the instructions may result in risk of injury to persons or property.
• Personnel installing and maintaining this equipment must be qualified Electricians with appro-
priate knowledge and experience who can identify and prevent Electrical hazards.
• Product is not independently isolated, ISOLATE the mains electricity supply before connecting
and observe any relevant safety precautions. Product must be connected to a switch fused
(spur/supply) or BS 1363 Plug. It is recommended a single Fuse Spur is used to supply the
FERRET and Load jointly so that they are isolated together.
• When Used to switch mains voltage Loads ensure the circuitry is suitable protected to prevent
electric shock.