www.switches-sensors.zf.com ZF Electronics Systems Pleasant Prairie, LLC (“ZF”) acquired the rights to the CHERRY branded switches
and sensors in 2008. Although ZF divested its interest in the CHERRY name in 2015, the switches and sensors remain unchanged and are now
sold under the ZF brand.
Page 1 of 2, Last update 2017-11-30, Specifications subject to change without notice.
Magnetic Proximity Sensors (Hall Effect)
MP1001 Sensors
Solid state magnetic proximity sensor
with electrical immunity protection
Description
The MP1 Series sensors are one-piece non-contact solid-state position sensors. The sensors operate through the use of Hall Effect
technology with magnetic fields generated by permanent magnets. They provide a sinking current output.
Features
Typical Applications
• Solid state reliability
• Stable output over operating temperature range
• Compatible with unregulated power supply
• South pole activated
• Open collector (sinking or NPN) output can be used with bipolar or
CMOS logic circuits with suitable pull-up resistor
• RoHS compliant
• IP67
• Door position & interlock
• Limit switch
• Flow/speed
• Home security
• Pedal switch
Environmental Specifications
Operating Temperature (MP100101)
-
40
°
C to 105
⁰
C (
-
40
⁰
F to 221
⁰
F)
Operating Temperature (MP100102)
-
40
°
C to 85
⁰
C (
-
40
⁰
F to 185
⁰
F)
Storage Temperature (MP100101)
-
40 °C to 105 °
C (
-
40
⁰
F to 221
⁰
F)
Storage Temperature (MP100102)
-
40 °C to 85 °
C (
-
40
°
F to 185
⁰
F)
Ingress Protection
IP67
Electrical Specifications
Supply Voltage
5 to 16 VDC
Supply Current
4.1 mA typ., 7.5 mA max.
Output Current (Sink)
25 mA max.
Maximum Input Voltage
24 VDC
Maximum Reverse Voltage
5 VDC
Recommended Pull
-
Up Resistor
See Chart
Mechanical Specifications
Housing Material
303 Stainless Steel
Maximum Installation Torque Limit
50 in lbs on
threads
Turn on / off
24
5
Gauss / 60 Gauss
Products
Part
N
umber
Termination
MP100101
12 mm, 4
-
pin circular mating connector;
type IEC 60947
-
5
-
2
MP100102
22 AWG x 1 m 3
-
wire shielded cable with drain
www.switches-sensors.zf.com ZF Electronics Systems Pleasant Prairie, LLC (“ZF”) acquired the rights to the CHERRY branded switches
and sensors in 2008. Although ZF divested its interest in the CHERRY name in 2015, the switches and sensors remain unchanged and are now
sold under the ZF brand.
Page 2 of 2, Last update 2017-11-30, Specifications subject to change without notice.
Note: An external pull-up resistor is required, the value of which is dependent on the supply voltage. The resistor should be connected
between the output and Vcc. Refer to the wiring diagram for lead colors or pin numbering as applicable.
Recommended External Pull-Up Resistor
Volts DC
5
9
12
15
Ohms
1k
1.
8k
2.
4k
3k
Open Collector Sinking Block Diagram
Dimensions mm (inches)
MP100101
MP100102