www.switches-sensors.zf.com
Page 1 of 2, Last update 2016-07-06, Specifications subject to change without notice.
Magnetic Proximity Sensors (Hall Effect)
MP1005 - MP1007 Sensors
Solid state magnetic proximity sensor
with electrical immunity protection
Description
The MP1 Series sensors are one-piece non-contact solid-state position sensors. The sensors operate through the use of Hall
Effect technology with magnetic fields generated by permanent magnets. They provide a sinking current output.
Features
Typical Applications
Solid state reliability
Stable output over operating temperature range
Compatible with unregulated power supply
South pole activated
Open collector (sinking or NPN) output can be used with bipolar or
CMOS logic circuits with suitable pull-up resistor
RoHS compliant
IP67
Door position & interlock
Limit switch
Flow/speed
Home security
Pedal switch
Environmental Specifications
Operating Temperature (MP100502)
-40 °C to 85 ⁰C (-40 ⁰F to 185 ⁰F)
Operating Temperature (MP100701)
-40 °C to 150 ⁰C (-40 ⁰F to 302 ⁰F)
Storage Temperature (MP100502)
-40 °C to 85 ⁰C (-40 ⁰F to 185 ⁰F)
Storage Temperature (MP100701)
-40 °C to 150 ⁰C (-40 ⁰F to 302 ⁰F)
Ingress Protection
IP67
Electrical Specifications
Operating Supply Voltage
5 to 24 VDC
Supply Current
4.1 mA typ., 7.5 mA max.
Output Current (Sink)
25 mA max.
Output Off Voltage
30 VDC
Maximum Input Voltage
30 VDC
Maximum Reverse Voltage
30 VDC
Recommended Pull-up Resistor
See chart
Mechanical Specifications
Housing Material
Aluminium
Maximum Installation Torque Limit
50 in lbs on threads
Turn on / off
245 Gauss / 60 Gauss
*Not commonly stocked; please contact the factory or your distributor.
Products
Housing Color
Termination
Red
20 AWG x 1 m
Black
20 AWG x 1 m
www.switches-sensors.zf.com
Page 2 of 2, Last update 2016-07-06, Specifications subject to change without notice.
Note: An external pull-up resistor is required, the value of which is dependent on the supply voltage. The resistor should be
connected between the output and Vcc. Refer to the wiring diagram for lead colors or pin numbering as applicable.
Recommended External Pull-Up Resistor
Volts DC
5
9
12
15
24
Ohms
1k
1.8k
2.4k
3k
3k
Open Collector Sinking Block Diagram
Dimensions mm (inches)
MP100502
MP100701