2SS-33A-R1
©2021 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 14, 2021
Page of 1 5
8-Port multibeam antenna ,8x 3100-4200 MHz , 4x 33° HPBW, 1x RET
Enhances network capacity and spectrum utilization when used in six sector applications
Reduces antenna count to minimize Cap-Ex and Op-Ex costs – 3 antennas required for 6 sector
configurations
Future proof-covers bands 42,43,48 plus C-Band and future CBRS expansions
General Specifications
Antenna Type Multibeam
Band Single band
Color Light Gray (RAL 7035)
Grounding Type RF connector inner conductor and body grounded to reflector and mounting
bracket
Performance Note Outdoor usage
Radome Material Fiberglass, UV resistant
Radiator Material Low loss circuit board
Reflector Material Aluminum
RF Connector Interface 4.3-10 Female
RF Connector Location Bottom
RF Connector Quantity, high band 8
Remote Electrical Tilt (RET) Information
RET Hardware CommRET v2
RET Interface AISG1 8-pin DIN Female |AISG1 8-pin DIN Male
RET Interface, quantity 1 female |1 male
Input Voltage 10–30 Vdc
Internal RET High band (1)
Power Consumption, active state, maximum 10 W
Power Consumption, idle state, maximum 2 W
Protocol 3GPP/AISG 2.0 (Single RET)
Dimensions
Width 301 mm|11.85 in
Depth 181 mm|7.126 in
2SS-33A-R1
©2021 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 14, 2021
Page of 2 5
Length 1100 mm|43.307 in
Net Weight, without mounting kit 12 kg|26.455 lb
Array Layout
Port Configuration
Electrical Specifications
Impedance 50 ohm
3100 – 4200 MHz