DESCRIPTION
Document No. 480 8590A 02/14/18 Page 1
SPECIFICATIONS
*Power will vary depending on the SDRAM used.
HX432C18FW/16
16GB 2G x 64-Bit
DDR4-3200 CL18 288-Pin DIMM
Continued >>
kingston.com/hyperx
FEATURES
HyperX HX432C18FW/16 is a 2G x 64-bit (16GB) DDR4-3200 CL18
SDRAM (Synchronous DRAM) 2Rx8, memory module, based on
sixteen 1G x 8-bit FBGA components per module.
Each module kit
supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0.
Each module has been tested to run at DDR4-3200 at a low latency
timing of 18-21-21 at 1.2V.
Additional timing parameters are
shown in the Plug-N-Play (PnP) Timing Parameters section
below. The JEDEC standard electrical and mechanical
specifications are as follows:
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command T ime (tRFCmin)
Row Active T ime (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
18 cycles
45.75ns(min.)
350ns(min.)
24.375ns(min.)
TBD W*
94 V - 0
0
o
C to +85
o
C
-55
o
C to +100
o
C
JEDEC/XMP TIMING PARAMETERS
• JEDEC/PnP: DDR4-3200 CL18-21-21 @1.2V
•XMP Profile #1: DDR4-3200 CL18-21-21 @1.2V
•XMP Profile #2: DDR4-2933 CL17-19-19 @1.2V
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP = 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.340” (34.04mm), w/heatsink
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.
HX432C18FW/1
1
B 2
x
4-Bi
DDR4 3200 CL18 288 Pin DIMM
Memory Module Specifications