Color
PROPERTY
Pink
TYPICAL DATA TEST METHOD
Density 740 kg/m³
Shore Hardness 80 D ASTM D2240
ASTM D694
ASTM D638
ASTM D790
Tensile Stress 27 MPa
Flexural Modulus 2100 MPa
•Classication St-1
Energy @ Peak Load 3.42 J
•Kst Value 93 m*bar/s
Energy @ Break 3.92 J
Total Energy 4.05J
Glass Transition Temperature (DSC) 135º C * ASTM E1356
Uniaxial Compressive Strength 55 MPa
Tensile Modulus 2600 MPa
Shear Strength ASTM D732
Coefcient of Linear Thermal Expansion (0 to 130°C) 40 x 10-6 / °C ASTM E831-14
Thermal Conductivity ( guarded hot plate) 90°C , (W/m/°K) 0.132 ASTM C518
ASTM E1226
ASTM D3763-18
Uniaxial Compressive Modulus 2655 MPa
Flexural Strength 28 MPa
Explosion Severity (machining chips)
Multi Axial High- Speed Impact
Heat Deection Temperature (TMA) 135º C * ASTM D648-18
TECHNICAL PROPERTIES
Product Sizes
TC760X is available in a standard board size of 24”
x 60” and in four different thicknesses:
* +/- 5
o
C
Storage
The board should be stored in a dry warehouse.
Health & Safety
Eye protection and a face mask should be worn
when working with Trelleborg TC760X.
Please refer to the Trelleborg MSDS.
Cutting Guidelines
TC760X can be sawn using carbide or diamond
coated saw blades or cutting wheels.
Bonding Guidelines
Large patterns can be constructed from boards
using the appropriately selected epoxy adhesive
system. Trelleborg adhesive system 551A/B is
recommended. The adhesive system must offer
adequate pot life and be capable of meeting the
mechanical and thermal properties of the tooling
board.
To ensure good bonding:
• The adhesive should be applied to both surfaces
(dust free) using a notched spatula.
• The surfaces should be brought together and a
uniform clamping pressure applied by either
mechanical or vacuum means.
• Any surplus adhesive that extrudes from bond
lines after curing can be machined off.
• Bonded joints should be left to cure for 24 hours
at ambient temperature for best results.
The recommended adhesive has matched
characteristics to the TC760X material.
Machining Advisory
In order to avoid board distortion, it is
recommended that stock removal should be taken
equally from opposing faces. Where this is not
possible, then the board should be supported by
and bonded to additional layers.
To minimize distortion when machining large at
boards, it is advisable to rough cut one face, invert
the board and machine the rear face, re-invert and
complete the machining. The board can be nished
by the use of successively ner grades of wet and
dry abrasive paper.
Length Width Thickness
Type 1
24” / 610mm 60” / 1,524mm 2” / 50.8mm
24” / 610mm 60” / 1,524mm 3” / 76.2mm
24” / 610mm 60” / 1,524mm 4” / 101.6mm
24” / 610mm 60” / 1,524mm 6” / 152.4mm
Type 2
Type 3
Type 4