PN0108

8-Port Power Over the NET™

Altusen's PN0108 is equipped with eight hotpluggable ports for easy server room management. Each port can be individually

controlled so that users can set the power on sequence and delay time for each port to allow equipment to be turned on in the

proper order. On/Off scheduling allows for preset start/shutdowns/restarts on a daily, weekly,monthly basis.The PN0108 is the most

convenient, reliable and cost effective way to obtain access to your server room remotely.*

Egenskaper

Remote power on / off / reboot control for eight outlets via TCP/IP and a built in RS-232 PON (Power Over the NET™) port

Local power on / off / reboot control via the PN0108's PON port to the computer's RS-232 port

Daisy chain up to 15 additional stations to control up to 128 outlets

Manual switching between Local and Remote access for each port via front panel push button switches

Individual control of each port - users can set the power on sequence and delay time for each port to allow equipment to be

turned on in the proper order

Easy setup and operation via a GUI interface

Provides three configuration/management methods: Browser; Telnet; or Console Terminal

Safe shutdown and rebooting for Windows systems*

Overcurrent protection and recovery for each AC port (110 V model only); total port overcurrent protection (both models) -

remote users can monitor the outlet status via the GUI interface

Separate circuits for the unit's power and the power to the devices - the power control status menu is still accessible even

when an overcurrent condition trips the devices' circuit breaker

On/Off scheduling - allows everything from a one-time start/shutdown, to daily, weekly, etc. starts/shutdowns at user-

specified times

Port grouping - perform the same action on a specified group of ports

LEDs for easy status monitoring

Two level (Administrator and User) security

Configuration can be reset

Firmware upgradeable - daisy chained stations receive the upgrade via the daisy chain bus

UL/TUV approved

Multiplatform support: Windows 2000/XP/Vista, Linux, Unix and FreeBSD.

*Safe shutdown and rebooting is supported if the Power Monitor utility has been installed

For more information about KVMs which can connect to PN0108, see Compatible KVM Table

*The PN0108 is not a stand-alone unit. It must be connected to the CN6000, PN9108, SN0108 or SN0116 to access these

features