GENERAL SPECIFICATIONS
Interfaces
WAN Single line or bonded VDSL2, single line or
bonded ADSL2+, RJ-14
One-port 10/100/1000 Ethernet (RJ-45)
AP-TLS, EAP-TTLS, EAP-SIM and (optional)
802.1x
LAN Concurrent Wi-Fi support for 802.11b/g/n/ac
Four-port 10/100/1000 Ethernet switch, RJ-45
USB3.0 network interface
(Optional) Single-port, dual line voice FXS, RJ-14
Embedded Firmware, Encoding and Access Protocols
VDSL2 Support
(Single Line or optional Bonded)
ITU-T G.993.2 VDSL2 Annex A and B
Support for profiles 8a, 8b, 8c, 8d, 12a, 12b,
17a, 30a
U0 Band (25 kHz to 276 kHz)
G.993.2 Annex K.3
(Packet Transfer Mode - PTM)
G.993.5 (vectoring)
G.997.1 (2012) VDSL2 physical layer OAM
G.998.4 (G.INP)
ADSL2+ Support
(Single Line or optional Bonded)
ITU G.992.5 with Amendment 2
ITU G.992.3 with Amendments 1 and 2
(INP up to 16)
K.3 Packet Transfer Mode support
Annex L (RE-ADSL2) and Annex M support
TR-100
Embedded Firmware, Encoding and Access Protocols (continued)
ADSL Support ITU G.992.1 and ANSI T1.413 Issue2
Annex A support
TR-067
ATM Adaptation Layer 5 (AAL5) Eight permanent virtual circuits (PVCs);
UBR, CBR, VBRnrt, VBRrt
ITU-T 1.610 (F4/F5) OAM
DHCP Client, PPP, or 802.1x Supplicant
Authentication
IP Addressing and Routing IPv4, IPv6 / 6rd
DHCP server
DNS proxy, dynamic DNS support
Multiple subnet support
Traffic Management and QoS
(Quality of Service)
Network Address Port Translation (NAPT)
Application Level Gateway (ALG) support
IP maps (pinholes)
Diffserv QoS with Weighted Fair Queuing
IGMPv2, IGMPv3 with Fast Leave
IEEE 802.1P/Q VLANs
DSCP setting for SIP/RTP
Speed Test
Deep Packet Inspection (DPI)
Security Stateful packet inspection firewall
Virtual DMZ/IP pass-through
Denial of service (DoS) protection
VPN pass-through (PPTP, L2TP, IPSec)
Device Management Password protected access, statistics, and
log reporting
Remote Management TR-069/TR-098, TR-104, TR-111, WebUI,
CLI (Telnet), SSH
NVG44x
Dual/Triple Play Residential Gateways
Service Assurance
The advanced features of the NVG44x-Series Gateways help Service Providers
improve efficiency and reduce costs. Support for 802.1x WAN supplicant
simplifies CPE authentication to the Service Provider network and eliminates
the subscriber need to manually enter their PPP credentials. The ARRIS 9x CPE
Software is scalable and forward looking, with the ability to support an
upgrade path to more advanced features such as OSGi and DPI. And, because
ARRIS designs its Gateways to be remotely manageable via industry standard
TR-069/TR-098, the NVG44x-Series Gateways are interoperable with any ACS
solution that follows the Broadband Forum’s TR-069/TR-098 specification.
Platform Optimization
The NVG44x-Series Gateways are available in two models, cost optimized to
meet the needs of the Service Provider:
• NVG443: VDSL2/ADSL2+ Gateway with 2.4GHz 802.11b/g/n and 5GHz 802.11ac
• NVG448: VDSL2/ADSL2+ Gateway with 2.4GHz 802.11b/g/n, 5GHz 802.11ac and VoIP
The features and specifications of the NVG44x-Series Gateways are further described below.
©ARRIS Enterprises, Inc. 2016 All rights reserved. No part of this publication may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation, or adaptation) without
written permission from ARRIS Enterprises, Inc. (“ARRIS”). ARRIS reserves the right to revise this publication and to make changes in content from time to time without obligation on the part of ARRIS to provide notification of
such revision or change. ARRIS and the ARRIS logo are all trademarks of ARRIS Enterprises, Inc. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and the
names of their products. ARRIS disclaims proprietary interest in the marks and names of others.