1/4
THST080D-RS485
Digital output current transmitter
Split core、 Crimping terminal output. Detect DC and pulse current， High insulation between
primary side and the vice side circuit.
1.Loosen the screw
2.Open up
3.In the lead 4.Tighten the screws
Installation diagram
Product features
•Light weight
•Low power consumption
•Good linearity
•No insertion loss
•Fast response time
•Good anti-interference ability
Product application
•Railway
•Metallurgical
•Welding machine
•Robot
•Motor
•Inverter power supply
•Variable frequency governor
•Uninterrupted power supply and communication power supply
www.poweruc.pl
2/4
RS485 Modbus RTU
9600bps(Acquiescence)
0X01(Acquiescence)
Parity check(Acquiescence)
Hexadecimal measurements
1%
0.5%
±15V/+12V/+24V
≤50mA
≤1000m
≤±15mV
≤20ms
650g
-10～+70℃
-40～+85℃
DC
2.5KV 50Hz 1min
400A
480A
500A 600A
720A600A
800A 1000A 1500A
1800A
2000A
2400A1200A960A
Remarks
Electrical parameters:（The following parameters are typical values and actual values
will be subject to product testing）
Rated input
Input
measurement range
Rated output
Accuracy
Linearity
Supply voltage(±5%)
Current consumption
Transmission distance
Zero offset TA=25℃
Response time
Communication protocol
Baud rate
Device address range
Check digit
Weight
Operation temperature
Storage temperature
Band width
Delectric strength
Choose three
Standard input
Default is 1.2 times the input rating
Reference will be subject to the measured
0X01~0XF7(Can be modified)
Odd check/no check (optional)
Factory test
14400bps/19200bps/38400bps/56000bps(optional)
500 m transmission line, baud rate is
56000bps, even check test results
Instruction for use：
1.Correct wiring as indicated
2.Full scale measurement, response time and following the speed for the best
3.Faulty wiring can lead to product damage and output uncertainty
As our products are constantly being improved and updated, we reserve the right to modify the content
of this specification at any time without prior notice.
Safe operation:
*Please read this specification carefully before use.
*When you need to move the product, please be sure to disconnect the power and all the connected cables.
*If found shell, devices attached to the fixed parts, wire, or have any damaged, please immediately
deal with hidden dangers.
*If there is any doubt about the safe operation of the equipment, the equipment and the corresponding
accessories should be closed immediately, and the fastest time for troubleshooting.
Proclamations：
www.poweruc.pl