1 / 7
Document No.
HI
M
-
1
0003
Confidential
C
© DAI-ICHI SEIKO Co., Ltd.
QKE-DFFDE09-03 REV.7
MHF
®
4 Connector
Part No.20448-001R-081, 20611-001R, 20449-001E, 20449-001E-**, 20449-001E-***
Instruction Manual
7 S18599
September 19, 2018
Y.Imaji K.Yufu K.Yotsutani
6 S18033 January 17, 2018 M.Nomoto S.Taguchi K.Yotsutani
5 S17477 June 26, 2017 M.Nomoto S.Taguchi K.Yotsutani
4 S16117 March 1, 2016 M.Nomoto S.Taguchi K.Yotsutani
Rev. ECN Date Prepared by Checked by Approved by
MHF 4 Connector Instruction Manual
Document No.
HIM-10003
2 / 7
Confidential
C
© DAI-ICHI SEIKO Co., Ltd.
弊社、MHF 4 Connector の取り扱いに際して、本コネクタを安全に御使用頂くことを目的としコネクタの挿入・抜去の手順及��注意点
を記述致します。
This manual is to explain the insertion & withdrawal methods and important points in handling of MHF 4 connector
PLUG with cable for the purpose of proper use.
【コネクタ型番】【Connector Parts Number】
MHF 4 PLUG 20448-001R-081, 20611-001R
MHF 4 RECEPTACLE 20449-001E, 20449-001E-**, 20449-001E-***
【挿抜 JIG について】【Pushing & Pulling JIG】
挿抜を行う際、ケ－ブルコネクタ首部へのストレスを避ける為、Fig. 1 の形状の様な JIG を御使用下さい。
ケ－ブル側コネクタには JIG 専用の引っかけ形状が設置されています。(Fig. 2)
To avoid excessive stress to cable connection points, it is recommended to use special jig as show in Fig. 1.
The cable connector has a design feature to hook this “Pushing & Pulling JIG”. (See Fig. 2)
(Fig. 1) 推奨 挿抜 JIG （Recommendation: Pushing & Pulling JIG Part No. 90435-001）
(Fig. 2) 抜去 JIG 引っかけ形状配置図（PLUG connector design feature to hook pull jig）
HOOK
Z