Doc. No.
DC Socket-81
Page No.
1/8
Date Issued
2020-04-06
Prepared by
Josephine
XKB Connectivity
Date revised
2020-11-23
checked by
Jay
Product Specification
Rev. No.
81
Approved by
Mei Chen
Title：DC Socket
1. SCOPE（适用范围）
This specification covers the performance, tests and quality requirements for the DC Socket .
本规范涵盖了DC Socket 的性能、测试和质量要求。)
2. PRODUCT DESCRIPTION（ 产品描述）
DESCRIPTION（描述）
Part Number（料号）
DC连接器 插脚 W9.0xD6.0xH5.0,内芯1.0,2A 12V
DC-003A-2A-1.0
3. APPLICABLE DOCUMENT （适用文件）
The following documents form a part of this specification to the extent specified herein. In the event of
conflict between the requirements of this specification and the product drawing, the product drawing
shall take precedence. In the event of conflict between the requirements of this specification and the
referenced documents, this specification shall take
precedence.（下列文件构成本规范的一部分，在此规定的范围内。本规范要求与产品图纸有冲突
时，以产品图纸为准。如果本规范的要求与参考文件发生冲突，应以本规范为准。）
4. REQUIREMENTS （要求）
4.1. Design and Structure （设计和结构）
Product shall be of the design, structure and physical dimensions specified on the applicable product
drawing.（产品的设计、结构和物理尺寸参考所适用的产品图纸）
4.2. Materials/ Finish (材料/表面处理)
Materials used in the structure of product shall be as specified on the applicable product drawing.
(产品结构中使用的材料参考所适用的产品图纸)
4.3. Ratings （额定功率）
Item（项目）
Standard（标准）
Doc. No.
DC Socket-81
Page No.
2/8
Date Issued
2020-04-06
Prepared by
Josephine
XKB Connectivity
Date revised
2020-11-23
checked by
Jay
Product Specification
Rev. No.
81
Approved by
Mei Chen
Title：DC Socket
Rated Voltage (Maximum)额定电压
12V DC
Rated Current (Maximum)额定电流
2A
Operating temperature range工作温度范围
-20℃～+70℃
From -20 to +70 egree centigrade
Storage Temperature Range储存温度范围
-20℃～+70℃
From -20 to +70 degree centigrade
5.0 TEST STANDARD （测试条件）
5.1 Unless otherwise specified, the standard range of atmospheric conditions for making
measurements and tests are as follows （除另有说明外，用以进行测量和测试的标准
环境条件范围如下）
Ambient temperature（环境温度）: 5℃ to 35℃
Normal humidity （正常湿度）: 45% to 85%
Air pressure （气压）: 86Kpa to 106Kpa
5.2 However if doubt arises on the decision based on the measured Values under the
above-mentioned Conditions.The following conditions shall be employed:
（但是在对判定产生疑问时,按下述状态实施）
Temperature （温度）：20±2℃
Relative humidity （相对湿度）：65±5%
Air pressure （气压）: 86Kpa to 106Kpa
6. PERFORMANCE AND TEST DESCRIPTION （性能和测试类型）
6.1 APPEARANCE （外观）
ITEM
DESCRIPTION（类型）
TEST CONDITION（测试条件）
REQUIREMENT（要求）