Document no.: DOC-0000278984 / 01.02.0777 Uncontrolled Copy

Issue no.: D Issued/Checked/Released: 4159/4417/09.2002

Supersedes: 09.2006 Last amended: 4772/04.2010 Page 1/1

WAIVER!

It is exclusively in written agreements that we provide our customers with warrants

and representations as to the technical contained specifications and/or the fitness

for any particular purpose. The facts and figures herein are carefully compiled to the

best of our knowledge, but they are intended for general informational purposes

only.

HUBER+SUHNER is certified according to ISO 9001 and ISO 14001

HUBER+SUHNER

–

Excellence in Connectivity Solutions

HUBER+SUHNER AG

RF Technology

9100 Herisau, Switzerland

Phone +41 (0)71 353 41 11

www.hubersuhner.com

HUBER+SUHNER®ANTENNAS

Security Instruction

Disclaimer:

Product data

All product data is non-binding and subject to change at any time.

Product performance

The products of HUBER+SUHNER are tested in a laboratory environment against specific standards and test

procedures and guaranteed to this level of performance. Any guarantee for exceptional applications or

environmental conditions is subject to special request.

ESD (Electrostatic Discharge) and Over-Voltage Protection

If a HUBER + SUHNER product is marked with an ESD label, protection against electrostatic discharge (ESD)

and/or over-voltage is essential while handling the product:

 Always ground yourself before removing the protection cap from the connector and

during installation.

 Always discharge the feeder cable before connecting it to the antenna.

 Do not exceed the supply voltage range specified in the product datasheet

 Observe the polarity of the power supply

All HUBER+SUHNER products are functionally tested prior to shipping. HUBER+SUHNER does not take

responsibility for damage caused to the ESD-sensitive device due to improper handling during unpacking or

installation.