Operation
IP65
Effective weatherproof casing.
RF Link
OK
Warning
DMX
RDM
DALI
Coexistence assured
WCRMX Outdoor Slim quick start guide
Link button
Clear indications
Check the current status at a
glance.
Weatherproof Wireless DMX/DALI
The WCRMX Outdoor Slim offers the same great circuitry as
standard WCRMX units housed within a neat IP65-rated
all-weather protective casing. The WCRMX Outdoor Slim
receiver can link with standard WCRMX transmitters in the
usual manner.
The WCRMX Outdoor Slim supports the USITT DMX512 and
DMX512-A standards, as well as DMX to DALI conversion in the
receivers.
Easy one-button operation.
See page 3 for details.
DI-001-WCRMX-04A.indd 1 5/4/11 12:12 PM
WEB VERSION
Connections
Correct use of the cable bushings
The supplied cable bushings will, when installed correctly, provide IP65 rated protection.
1 Insert the appropriately
sized cable into the
bushing. Feed an
additional 3/8” (1CM)
of cable into the
box.
3
2
*Shown with back cover removed.
85-264VAC power input/output
Warning! To avoid death, injury or
property damage, Disconnect line power
before connecting, disconnecting, or
whenever opening the enclosure.
DMX+
DMX-
Not Used
DALI out
Neutral in (85-264V AC)
Line power in
Hot in (85-264V AC)
DALI out
COMMON
}
DMX connects to the screwless pluggable terminal on the side of the enclosure at the top cable entry through the
nipple/bushing. Line power and DALI connects to the screwless pluggable terminal at the bottom cable entry of the
enclosure through the nipple/bushing. The side bottom cable entry is not used.
DMX cable specifications
Min outer diameter: 0.3” (8mm)
Max outer diameter: 0.5” (13mm)
Conductor size: 28-20 AWG (0.08-0.5mm2)
Insulation strip length: 0.2-0.25” (5-6mm)
Line/DALI cable specifications
Min outer diameter: 0.3” (8mm)
Max outer diameter: 0.5” (13mm)
Conductor size: 28-16 AWG (0.08-1mm2)
Min insulation strip length: 0.2” (4mm)
NOTE: The Line Power/DALI terminal
block can be detached to facilitate
easier cable termination.
Place a cable
tie around the
bushing as
indicated on the
drawing. Tighten
the cable tie and
cut off the
excess material.
Pull the cable 3/8" (1cm)
out of the enclosure so
that the cable tied part of
the bushing folds into the
main part of the
bushing as
indicated on
the drawing.
DI-001-WCRMX-04A.indd 2 5/4/11 12:12 PM
WEB VERSION