MODEL: FB-S-107128
FEATURES
• Single input and output
• Insertion loss......................... 5 dB maximum
• Amplitude balance ................ 0.5 dB maximum
• VSWR ..................................... 1.5:1 maximum
SWITCHABLE FILTER BANK
MITEQ’s Model FB-S-107128 integrated, two part, switchable filter bank features two channelized, printed circuit
filter banks, individually selectable by TTL driven, SP2T PIN switches the input and output. MITEQ’s Microwave
Control Products Group specializes in the manufacture of integrated switch filter assemblies and is able to offer a
wide range of frequency ranges and a number of channels.
ELECTRICAL SPECIFICATIONS
PARAMETERS BAND 1 BAND 2
Passband frequency 10.7–11.8 GHz 11.7–12.75 GHz
Insertion loss 5 dB maximum 5 dB maximum
Insertion loss flatness 0.7 dB maximum, 0.2 dB any 36 MHz band 0.7 dB maximum, 0.2 dB any 36 MHz band
Difference in band level 0.5 dB maximum 0.5 dB maximum
VSWR 1.5:1 maximum 1.5:1 maximum
Group delay (any 40 MHz band)
Linear 0.01 ns/MHz maximum 0.01 ns/MHz maximum
Ripple 0.5 ns p-p maximum 0.5 ns p-p maximum
Rejection 14.88–15.98 GHz > 80 dB 15.88–16.91 GHz > 80 dB
12.79–13.89 GHz > 50 dB 13.79–14.84 GHz > 50 dB
Switch positions Select E1 = 0 V Select E2 = 0 V
Return voltage 5 V 5 V
ENVIRONMENTAL CONDITIONS
Operating temperature ............................................. 0 to 70°C
Storage temperature ................................................ -30 to +85°C
Humidity ................................................................... 95% noncondensing
Vibration ................................................................... 12 g’s rms, 20-2000 Hz per MIL-STD-810B Method 514, Procedure 5
FUNCTIONAL BLOCK DIAGRAM
0.38 [9.65]
0.85
[21.59]
2.67 [67.82]
E2
J1
J2
RTN
E1
0.90 [22.86]
1.63
[41.40]
1.85
[46.99]
0.11
[2.79]
4.47 [113.54]
0.13 [3.30]
DIA. 0.102 [2.591] DIA. THRU
C'BORE 0.188 [4.775] (4) HOLES X 0.13 [3.30] DEEP TYP.
TYPE. "SMA"
MALE CONNECTOR
(TYP. 2 PLACES)
BAND 1: 10.7–11.8 GHz
BAND 2 : 11.7–12.75 GHz
J1
J2
GENERAL NOTES:
1. Dimensions shown in brackets [ ] are in millimeters.
2. Tolerance as follows: .xx = ±0.01 [.xx = ±0.25], .xxx = ±0.005 [.xxx = ±0.13]
OUTLINE DRAWING
100 Davids Drive, Hauppauge, NY 11788 • TEL: (631) 439-9220 • FAX: (631) 436-7430 • www.miteq.com
C-35C/117