P/N: 1802001040013
*1802001040013*
EOM-104
Quick Installation Guide
Moxa Embedded Ethernet Switch Module
Edition 4.0, February 2017
Technical Support Contact Information
www.moxa.com/support
Moxa Americas:
Toll
-free: 1-888-669-2872
Tel:
1-714-528-6777
Fax:
1-714-528-6778
Moxa China (Shanghai office):
Toll
-free: 800-820-5036
Tel:
+86-21-5258-9955
Fax:
+86-21-5258-5505
Moxa Europe:
Tel:
+49-89-3 70 03 99-0
Fax:
+49-89-3 70 03 99-99
Moxa Asia-Pacific:
Tel:
+886-2-8919-1230
Fax:
+886-2-8919-1231
Moxa India:
Tel:
+91-80-4172-9088
Fax:
+91-80-4132-1045
2017 Moxa Inc. All rights reserved.
- 2 -
Overview
The EOM-104 Series Ethernet switch module provides an easy,
cost-effective, and integrated solution for device manufacturers to embed
an Ethernet switch module into an existing product for enhanced
performance and reliability.
The module supports 10/1 00 Mbp s Fast Eth ernet, and com es with Tu rbo
Ring’s fast recovery time of under 20 ms built in. The EOM-104 Series also
provides a rich set of peripherals (e.g., GPIO programming pins and DIP
switches to enable Turbo Ring) and is an ideal solution for embedded
Ethernet applications.
Package Checklist
The EOM-104 Series Evaluat ion Kit package contains the following items:
• EOM-104 series module
• EOM-104 series evaluation board
• Universal power adaptor
• 2 power cords
• Null modem serial cable
• Cross-over Ethernet cable
• Accessories pack
• Quick installation guide (printed)
• Warranty card
Note: Please notify your sales representative if any of the above items are
missing or damaged.
First-Time Installation and Configuration
Before installing the EOM-104 Series, please check to make sure that all
items in the Package Checklist are in the box.
Hardware Installation Procedure
Step 1: Plug the EOM-104 Series into the evaluation board.
Plug the EOM-104 Series module into the sockets on t h e top of the
evaluation board
Step 2: Connect the power source to the evaluation board.
Connect the 12 VDC power line to the evaluation board’s power jack.
Step 3: Connect the network cable to the evaluation board.
Use the RJ45 Ethernet cable to connect the Ethernet port on the
evaluation board to an Et h ernet network for evaluation.
Step 4: Set up the computer’s IP address.
In a Windows environment, the IP address can be changed in th e TCP/IP
Settings window. Select an IP address on the same subnet as the
EOM-104 Series. Since th e default IP address of the EOM-104 is
192.168.127.253, and the subnet mask is 255.255.255.0, you should set
the IP address of the computer to 192.168.127.xxx.
Step 5: Configure the EOM-104 Series.
Please refer to EOM-104 Series User’s Manual.