- 2 -

Overview

The OnCell G3150A-LTE is a reliable, secure, LTE gateway with

state-of-the-art global LTE module. This 4G cellular gateway provides a

more reliable connection to your Ethernet network for cellular

applications.

To enhance industrial reliability, the OnCell G3150A-LTE features isolated

power inputs, which together with high-level EMS and wide-temperature

support give the OnCell G3150A-LTE the highest level of device stability

for any rugged environment. In addition, with dual-SIM GuaranLink and

dual power inputs, the OnCell G3150A-LTE supports network redundancy

to ensure uninterrupted connectivity.

The OnCell G3150A-LTE also comes with a 3-in-1 serial port for serial over

LTE cellular network communication. Use the OnCell G3150A-LTE to

collect data and exchange data with serial/Ethernet devices.

Package Checklist

Moxa’s OnCell G3150A-LTE is shipped with the following items. If any of

these items is missing or damaged, please contact your customer service

representative for assistance.

• 1 OnCell G3150A-LTE unit

• 2 2G/3G/4G antennas 2 dBi omni-directional with SMA male

connectors

• 1 DIN-rail mounting kit

• Quick installation guide (printed)

• Warranty card

Installation and Configuration

Before installing the OnCell G3150A-LTE, make sure that all items in the

package checklist are in the box. In addition, you will need access to a

notebook computer or PC equipped with an Ethernet port. The OnCell

G3150A-LTE has a default IP address that you must use when connecting

to the device for the first time.

Take the following steps to configure your OnCell G3150A-LTE. Refer to

the Panel Layout of the OnCell G3150A-LTE section below for the location

of the ports and sockets.

Step 1: Insert a SIM card and turn on the OnCell G3150A-LTE

1. Use a screwdriver to loosen the screws and remove the SIM card

cover.

2. Insert one or two 2G/3G/4G SIM cards (full-sized SIM/1FF) into the

SIM card slots located on the bottom of the OnCell G3150A-LTE.

If you are only using one SIM card, insert it in the top slot (slot 1; the

card in slot 1 is referred to as SIM1).

By default, the SIM card in the slot 1 is treated as the primary card.

To change the default to SIM2 (the card in slot 2), log in to the

OnCell’s web UI, and configure SIM2 as the primary card. When the

OnCell device is turned on, it boots up based on the configuration

information stored on the primary SIM card.

3. Turn on the OnCell G3150A-LTE by connecting a power terminal

block to a DC power source (12 to 48 VDC). For details refer to the

Connecting the Power Input section.

4. Reattach the cover.