Reworking 0.80 mm SEARAY
TM
SEAX8 High Speed Connectors
©Samtec, Inc. Phone: 1-800-SAMTEC-9 Rev.: A
www.samtec.com 812-944-6733 Date: September 27, 2017
Page: 1 Email: info@samtec.com Created by: Lance Cooper
Reworking 0.80 mm SEARAY
TM
SEAX8 High Speed Connectors
This document describes the recommended procedure for reworking (connector removal, site cleaning,
and connector replacement) Samtec’s 0.80 mm SEARAY
TM
SEAX8 connectors using hot air rework
equipment.
Equipment Used:
Air-Vac DRS27 BGA/SMT rework machine
Air-Vac NT583LZ2822S hot air rework nozzle
Other Materials:
SEAF8-50-05.0-S-10-2 connector
Alpha OM-338 Pb-free, no-clean solder paste
Kester TSF-6522 no-clean rework flux
Mini-stencil
PCB thickness .093
______________________________________
Thermal Profiling
Prior to each process, a complete thermal profile
study shall be completed. Thermocouples shall
be placed directly beneath the center of the
component as well as on the insulator body. The
ideal process will replicate the temperature
gradient and ramp rate as recommended by the
solder paste manufacturer.
Figure 1. Thermocouple Placement
Process 1 – Connector Removal
▪ Place board to be reworked on hot air
rework machine.
Figure 2. Board Placed on Rework Machine
▪ Align nozzle over component.
▪ If possible, apply tacky flux to solder joints
along each side of the connector.
Figure 3. Flux Application