12/1/2012 5:51:09 PM 1/4
1
ACDC_LinkSwitch-PH_101
612; Rev.1.9; Copyright
Power Integrations 2012
INPUT INFO OUTP UNIT
LinkSwitch-PH_101612: Flyback
Transformer Design Spreadsheet
2
ENTER APPLICATION VARIABLES
Design Title
3
Dimming required NO NO
Select 'YES' option if dimming is required.
Otherwise select 'NO'.
4
VACMIN 190 190 V Minimum AC Input Voltage
5
VACMAX 265 V Maximum AC input voltage
6
fL 50 Hz AC Mains Frequency
7
VO 30.00 30 V Typical output voltage of LED string at full load
8
VO_MAX 33.00 V Maximum expected LED string Voltage.
9
VO_MIN 27.00 V Minimum expected LED string Voltage.
10
V_OVP 35.00 V Over-voltage protection setpoint
11
IO 1.00 1.00 A Typical full load LED current
12
PO 30.0 W Output Power
13
n 0.90 0.9
14
VB 18 18 V Bias Voltage
15
16
17
ENTER LinkSwitch-PH VARIABLES
18
LinkSwitch-PH LNK419 LNK419 Univers 115 Doubled/230V
19
Chosen Device LNK419
20
Current Limit Mode RED RED
Select "RED" for reduced Current Limit mode or
"FULL" for Full current limit mode
21
ILIMITMIN 2.35 A Minimum current limit
22
ILIMITMAX 2.73 A Maximum current limit
23
fS 66000 Hz Switching Frequency
24
fSmin 62000 Hz Minimum Switching Frequency
25
fSmax 70000 Hz Maximum Switching Frequency
26
IV 80.3 uA V pin current
27
RV 3.909 M-ohm Upper V pin resistor
28
RV2 1.402 M-ohm Lower V pin resistor
29
IFB 180.00 180.0 uA FB pin current (85 uA < IFB < 210 uA)
30
RFB1 83.3 k-ohms FB pin resistor
31
VDS 10 V LinkSwitch-PH on-state Drain to Source Voltage
32
VD 0.50 0.50 V
Output Winding Diode Forward Voltage Drop
(0.5 V for Schottky and 0.8 V for PN diode)
33
VDB 0.70 0.70 V Bias Winding Diode Forward Voltage Drop
34
35
36
Key Design Parameters
37
KP 0.60 0.60
Ripple to Peak Current Ratio (For PF > 0.9, 0.4 <
KP < 0.9)
38
LP 1588 uH Primary Inductance
39
VOR 100.00 100 V Reflected Output Voltage.
40
Expected IO (average) 1.01 A Expected Average Output Current
41
KP_VACMAX 0.75 Expected ripple current ratio at VACMAX
42
TON_MIN 3.19 us Minimum on time at maximum AC input voltage
43
PCLAMP 0.31 W Estimated dissipation in primary clamp
44
45
ENTER TRANSFORMER CORE/CONSTRUCTION VARIABLES
46
Core Type EF30 EF30 Transformer core
47
Custom Core If using a custom core - Enter part number here
48
AE 0.6 cm^2 Core Effective Cross Sectional Area