File E28476
Project 88ME4007
October 18, 1988
REPORT
on
COMPONENT - ATTACHMENT PLUGS, FUSELESS
Amp Inc.
Harrisburg, PA
Copyright 1988 Underwriters Laboratories Inc.
Underwriters Laboratories Inc. authorizes the above-named company to
reproduce this Report provided it is reproduced in its entirety.
Underwriters Laboratories Inc. authorizes the above-named company to
reproduce that portion of this Report consisting of this Cover Page through
Page 1.
File E28476 Vol. 23 Sec. 10 Page 1 Issued: 1988-10-18
Vol. 25 Sec. 23 Revised: 2019-11-25
and Report
D E S C R I P T I O N
PRODUCT COVERED
Component Connectors- Standard Edge .050 Series, Standard Edge EISA
Series , PCIE Gen4 Card Edge Connector series.
GENERAL
* These devices are multipole edgecard connectors employing solder
terminals intended for soldering to a printed wiring board.
ENGINEERING CONSIDERATIONS (NOT FOR UL REPRESENTATIVE USE)
Use - For use only in complete equipment where the acceptability of the
combination is determined by Underwriters Laboratories, Inc.
Conditions of Acceptability - In order to be judged acceptable as a
component of electrical equipment, the following conditions should be met.
1. These devices should be used only where they will not interrupt the
current. 2. These devices have not been tested for current-carrying
capability.
3. The suitability of the mounting means shall be determined in the end
use.
4. The electrical and mechanical suitability of the wiring terminals
shall be determined in the end use.
5. The placement of these devices within the equipment enclosure should
be such that spacings between the live parts and the equipment are suitable
for the particular application.
6. The suitability of the minimum 0.36 mm (0.014 in) spacings between
live parts of opposite polarity (including adjacent poles) and between live
parts and exposed dead metal parts shall be determined in the end use.
Dielectric testing has not been performed.
7. The electrical and mechanical contact between the connector and the
printed wiring board is to be judged in the end-use equipment.