di uscita per rientrare in tale limite.
into that limit.
DATASHEET
EN1737
0-10V WITH DIP-SWITCH
1 CHANNEL
V0.3_M.C.
13/12/2019
Multidriver48 - COSTANT CURRENT OUTPUT
Specifiche tecniche Technical specifications
Tipo di
ingresso
Input Type Class2, LVLE, LED Class 2
Approvato per Rated for
Ambiente umido (secco & umido)
Damp (Dry & Damp)
Codici d'ordine Order codes
1200EN1737-1DS-0-0010M00
Senza cavi / without wires
1200EN1737-1DS-C-0010M00
Con cavi / with wires
Versione con cavi:
- 1 cavo rosso lunghezza 20mm sezione AWG20 UL
ingresso + Alimentazione
- 1 cavo nero lunghezza 20mm sezione AWG20 UL
ingresso – Alimentazione
- 1 cavo arancio lunghezza 20mm sezione AWG20 UL ingresso + 0-10V
- 1 cavo nero lunghezza 20mm sezione AWG20 UL ingresso – 0-10V
Version with wires:
- 1 red wire 20mm length AWG20 section UL on + power supply input
- 1 black wire 20mm length AWG20 section UL on – power supply input
- 1 orange wire 20mm length AWG20 section UL on + 0-10V input
- 1 black wire 20mm length AWG20 section UL on – 0-10V input
1 Nel caso in cui venga superata la massima temperatura di funzionamento consentita, il driver si
spegne automaticamente.
Per poterlo riaccendere,
è necessario scollegare l'alimentazione ed attendere che si abbassi la temperatura sotto la
soglia massima
per poi alimentare nuovamente.
1 In case the maximum operating temperature is exceeded, the driver turns off automatically.
In order to switch it on again,
it is necessary to disconnect the power supply and wait for the temperature to drop below the
maximum threshold.
After this it is possible to re-connect the power supply.
2 Nel caso in cui l'uscita superasse la soglia massima di 30W,
verrà limitata la corrente di uscita per rientrare in tale limite.
Per poter ripristinare il valore di corrente settata,
scollegare l'alimentazione e ridurre il carico in uscita sotto la soglia massima
poi alimentare nuovamente.
2 If the output get over 30W upper limit
output current will be limited in order to fall into that limit,
In order to restore set current value,
take off the power supply and reduce output load under maximum threshold
then re-connect the power supply.
3 Vedere tabella “Iout setting” a pagina 3 3 See “Iout setting” table on page 3
4 ±1,5% secondo test report Entity da 200mA a 1000mA @ 25°C 4 ± 1,5% according to Entity test report from 200mA to 1000mA @ 25°C
www.entityel.com info@entityel.it 2 / 3