Syncronising Xsens Systems with
Vicon Nexus
Step – by – step manual
16 – 01 – 2020
© 2005-2020, Xsens Technologies B.V. All rights reserved. Information in this document is subject to change
without notice. Xsens, MVN, MotionGrid, MTi, MTi-G, MTx, MTw, Awinda and KiC are registered trademarks
or trademarks of Xsens Technologies B.V. and/or its parent, subsidiaries and/or affiliates in The Netherlands,
the USA and/or other countries. All other trademarks are the property of their respective owners.
1
www.xsens.com
Table of Contents
1 Synchronization Workflow ........................................................ 2
2 Required Hardware ................................................................... 3
3 Hardware connections scheme .................................................. 4
4 MVN Analyze as Master and Vicon Nexus as slave ..................... 5
4.1 Start and Stop a recording .......................................................................... 5
4.1.1 Hardware connections ........................................................................... 5
4.1.2 Vicon Nexus Software ............................................................................ 5
4.1.3 Xsens Software..................................................................................... 6
5 Using the Link System ............................................................... 7