DS892 (v1.18) May 21, 2019 www.xilinx.com
Product Specification 1
© Copyright 2013–2019 Xilinx, Inc. Xilinx, the Xilinx logo, Alveo, Artix, ISE, Kintex, Spartan, Versal, Virtex, Vivado, Zynq, and other designated brands included herein are
trademarks of Xilinx in the United States and other countries. All other trademarks are the property of their respective owners.
Summary
The Xilinx® Kintex® UltraScale™ FPGAs are available in -3, -2, -1, and -1L speed grades, with -3 having the
highest performance. The -1L devices can operate at either of two V
CCINT
voltages, 0.95V and 0.90V and
are screened for lower maximum static power. When operated at V
CCINT
= 0.95V, the speed specification
of a -1L device is the same as the -1 speed grade. When operated at V
CCINT
= 0.90V, the -1L performance
and static and dynamic power is reduced.
DC and AC characteristics are specified in commercial, extended, industrial, and military temperature
ranges. Except the operating temperature range or unless otherwise noted, all the DC and AC electrical
parameters are the same for a particular speed grade (that is, the timing characteristics of a -1 speed
grade industrial device are the same as for a -1 speed grade commercial device). However, only selected
speed grades and/or devices are available in each temperature range.
All supply voltage and junction temperature specifications are representative of worst-case conditions.
The parameters included are common to popular designs and typical applications.
This data sheet, part of an overall set of documentation on the UltraScale architecture-based devices, is
available on the Xilinx website at www.xilinx.com/documentation
.
DC Characteristics
Kintex UltraScale FPGAs Data Sheet:
DC and AC Switching Characteristics
DS892 (v1.18) May 21, 2019
Product Specification
Table 1: Absolute Maximum Ratings
(1)
Symbol Description Min Max Units
FPGA Logic
V
CCINT
Internal supply voltage –0.500 1.100 V
V
CCINT_IO
(2)
Internal supply voltage for the I/O banks –0.500 1.100 V
V
CCAUX
Auxiliary supply voltage –0.500 2.000 V
V
CCBRAM
Supply voltage for the block RAM memories –0.500 1.100 V
V
CCO
Output drivers s upp ly vol t ag e for HR I/O banks –0.500 3.4 00 V
Output drivers s upp ly vol t ag e for HP I/O banks –0.500 2.0 00 V
V
CCAUX_IO
(3)
Auxiliary supply voltage for the I/O banks –0.500 2.000 V
V
REF
Input reference voltage –0.500 2.000 V
V
IN
(4)(5)(6)
I/O input volt ag e for HR I/O bank s –0.400 V
CCO
+ 0.550 V
I/O input volt ag e for HP I/O banks –0.550 V
CCO
+ 0.550 V
I/O input voltage (when V
CCO
= 3.3V) for V
REF
and differential I/O
standards except TMDS_33
(7)
–0.400 2.625 V