Technical Data Sheet
Measurement Cables
Rosenberger-OSI GmbH & Co. OHG
Tel.:+49 821 249249-0
www.rosenberger.com/osi ; E-Mail: info-osi@rosenberger.com
Page
1 / 2
Dieses Dokument ist urheberrechtlich geschützt ● This document is protected by copyright ● Rosenberger
OSI GmbH & Co.
OHG
Properties
• Reliable measurements with excellent repeatability thanks to measurement cables with precisely specified
Connectors.
• Measurement cable connectros that conform to particularly low tolerances.
• Connectros with wear-resistant ceramic ferrules.
• Singlemode: The limit value for the eccentricity of the fiber core is 0.3 µm and the maximum permitted value
for Apex offset is 30 µm.
Form of Delivery
• With individually documented report.
To enable us to guarantee the outstandingly low tolerances of our
measurement cables, these pass through a number of exceptionally
demanding test procedures, such as this insection at the eccentricity
measuring device.
Technical Data Sheet
Measurement Cables
Rosenberger-OSI GmbH & Co. OHG
Tel.:+49 821 249249-0
www.rosenberger.com/osi ; E-Mail: info-osi@rosenberger.com
Page
2 / 2
Dieses Dokument ist urheberrechtlich geschützt ● This document is protected by copyright ● Rosenberger
OSI GmbH & Co.
OHG
The eccentricity measurement device is used to check whether
the fiber core is located exactly in the center of the ferrule.
The quality requirements permit a maximum eccentricity of
0.3 µm. The value measured for the sample shown here is less
than 0.25 µm.
The interferometer is used to measure the geometry of the ferrule
endface, which is then displayed using a range of imaging methods.
Here again, only the tiniest tolerances are permitted.
Connectors
Part Numbers
LC
081A1430
MU
081A1413
SC
081A0143
E-2000™ HRL
081A1447
The table lists the most frequent types. We would be delighted to supply you
with your own customized configuration
Date
Approved
Date
Rev.
Engineering change number
Name
Date
14.06.2018
H. Jungbäck
14.06.2018
001
Y. Zhang
14.06.2018
While the information has been carefully compiled to the best of our knowledge, nothing is intended as representation or warranty on
our part and no statement herein shall be construed as recommendation to infringe existing patents. In the effort to improve our
products, we reserve the right to make changes judged to be necessary.