1 / 11
Specifications are subject to changes without notice.
SDD-AAPNP Rev. C
www.inventronics-co.com Tel: 86-571-56565800 Fax: 86-571-86601139 sales@inventronics-co.com
Programmer for LED Drivers and Intelligent Controllers
Description
SDD-AAPNP is the programmer for non-DALI Inventronics drivers,
and the programmer and calibrator for the following intelligent controllers:
• SDD-AAPNx Dimming Signal Attenuator
• TDD-ANPNx Combo Dimming Controller
Model
Name Description P/N
Programmer Programmer with calibration function SDD-AAPNP
Interface Specifications
Parameter Min. Typ. Max. Notes
Vaux Voltage 9.8 V 12 V 13.2 V
Vaux Source Current 0 - 10 mA
Programming Voltage
Rating
0 - 15 V
Programming Sink
Current
0 - 2 mA
(Vo+ - Vo-) Voltage
Rating
0 - 500 V
(Vo+ - Vo-) Current
Rating
0 - 8A/total 4A per Pin
(LED+ - LED-) Voltage -
(Vo+ - Vo-)
Voltage
-
Short circuit protection relies on the protection
of the LED driver.
(LED+ - LED-) Current -
(Vo+ - Vo-)
Current
-
Environmental Specifications
Parameter Min. Typ. Max. Notes
Operating Ambient
Temperature
-20 ℃
-
+50 ℃
Humidity: 10%RH to 90%RH.
No condensa tion.
Storage Temperature
-40 ℃
-
+70 ℃
Humidity: 5%RH to 90%RH.
No condensa tion.
2 / 11
Specifications are subject to changes without notice.
SDD-AAPNP Rev. C
www.inventronics-co.com Tel: 86-571-56565800 Fax: 86-571-86601139 sales@inventronics-co.com
Programmer for LED Drivers and Intelligent Controllers
General Specifications
Parameter Min. Typ. Max. Notes
Dimensions (L × W × H)
Inches
Millimeters
3.35 × 1.85 × 0.83
85 × 47 × 21
Net Weight - 45 g -
Note: All specifications are typical at 25 °C unless otherwise stated.
Packing List
Packing List Function
SDD-AAPNP Programmer
USB wire Connect PC and Programmer
UL Wire with UL female
connector
Connect Programmer and SDD-AAPNx or TDD-ANPNx (has male connector)
Programmer Interface Software
From the following website, download and follow the Installation Instructions for Programming Interfaces:
http://www.inventronics-co.com/download.aspx?c_kind=3&c_kind2=17&c_kind3=154
Note the installed software automatically checks for updates over the internet.
Connections
z For programmable drivers, the programming system connection is shown as below.
Note: The driver does not need to be powered on during the programming process.
Pin Connection Pin Connection
Vaux To LED driver’s dimming interface (Vaux) USB To PC
Programming To LED driver’s dimming interface (Vdim+) - -
Return
To LED driver’s dimming interface (Vdim-
/Return)
- -