Property Test Method Value

Uncured product

Appearance Red Paste

Cure Type Acetoxy

Extrusion Rate g/min 255 g/min

FDA CFR (21] 177.2600 No

Max Cure Hrs @ 25 °C 7 hrs

Rheology Paste

Colour Red

Duro Shore A ASTM D 2240-95 35

Elongation % ISO 37 410 %

Linear Shrinkage % 0.8 %

Max Working Temp +°C AFS_1540B 300 °C

Min Working Temp - °C -50 °C

Modulus @ 100% Strain MPa 0.98 MPa

Modulus Youngs MPa 0.71 MPa

SG BS ISO 2781 1.09

Tear kN/m BS ISO 34-1 6.3 kN/m

Electrical properties

Dielectric Constant @ 1kHz ASTM D-150 2.68

Dielectric Strength kV/mm ASTM D-149 >18 kV/mm

Dissipation Factor @ 1kHz ASTM D-150 0.002

Surface Resistivity ohms ASTM D-257 4.04E+14 ohms

Volume Resistivity ohms cm ASTM D-257 3.95E+16 ohms cm

Adhesion testing

Lap Shear Stainless Steel

304 kg/cm²

ASTM D1002 5 kg/cm²

Introduction

This is a 1-part, RTV (Room Temperature Vulcanising) silicone

adhesion to many substrates and cures rapidly at room

temperature when in contact with atmospheric moisture. This

product is not to be recommended for use with copper and its

associated alloys or in electronic assemblies.

Key Features

Flexible from -50 to +300ºC

Good electrical insulation properties

Excellent adhesion to most substrates

Use and Cure Information

This product is a ready for use 1 Part system. If supplied in

cartridges it can be applied using either manual or pneumatic

surface brought into contact with it within the tack free time stated

opposite. For optimum bond strength, the thickness of the sealant

joint should be a minimum of 1 mm.

The sealant will cure upon exposure to atmospheric moisture,

ideally between 20 to 30 ºC and 40% to 70% Relative Humidity.

Time taken for cure will depend on the thickness of the joint,

humidity and temperature. Joints should be left undisturbed for at

least 24 hours, but preferably longer to effect sufficient depth of

cure. Full cure requires 7 days.

“For pneumatic dispensing of 310 ml cartridges, the

CHT Adhesives are available in a variety packaging including

cartridges and bulk containers. Please contact our sales

department for more information.

Revision Date : 02/11/2017

Download Date : 09/08/2019

Technical Data Sheet

The information and recommendations in this publication are to the best of our knowledge reliable. However, nothing herein is to be construed as warranty or

representation. Users should make their own test to determine the applicability of such information or the suitability of any products for their own particular

purposes. Statements concerning the user of the products described herein are not to be construed as recommending the infringement of any patent and no liability

for infringement arising out of any such use is to be assumed. All values are typical and should not be accepted as a specification