U.S.A.: 908-272-5500 • U.K.: 44-1476-590600 • Spain: 34-91-4810178
Conductive Coatings
ELECTRICALLY CONDUCTIVE ACRYLIC AND POLYURETHANE PAINTS
G. CONDUCTIVE SYSTEMS
GENERAL DESCRIPTION
TECKNIT manufactures a highly conductive
acrylic and polyurethane paints filled with silver.
These coatings provide a cost effective method
for shielding and grounding plastic enclosures,
which are susceptible to EMI, and other applica-
tions requiring a flexible protective shield.
SHELF LIFE AND STORAGE
RECOMMENDATIONS
It is recommended the ACRYLIC-1 paint be used
within six months of the manufactured date and
the POLYURETHANE paints be used within nine
months of the manufactured date. All conductive
coating containers should be stored in the
“upside-down” position and at a temperature
between 50°F and 86°F [10°C and 30°C].
DO
NOT FREEZE CONDUCTIVE COATINGS.
PAINT PREPARATION
Before and during use, CONDUCTIVE COATINGS
should be thoroughly stirred. Each component of
the two and three part polyurethane coatings
should be stirred prior to combining. The compo-
nents of the two and three part systems are sup-
plied as a premeasured kit.
SAFETY AND USAGE CAUTIONS
TECKNIT CONDUCTIVE ACRYLIC AND
POLYURETHANE PAINTS contain a flammable
solvent and should be used in a well ventilated
area. Avoid direct skin contact and inhalation of
vapors. Prevent contact with eyes. Do not use
near open flame. Industrial use only
. Some indi-
viduals may experience skin irritation - wash with
mild soap and rinse with clear water. Contact
physician should ir
ritation occur.
SURFACE PREPARATION
T
o ensure the best electrical and mechanical reli-
ability, remove all grease, oils, dirt, mold releases
and foreign matter. Preparation should be in
accor
dance with standar
d practice for one-
coat painting. Recommended cleaning agent
is alcohol.
RECOMMENDED THINNING
THINNING IS REQUIRED FOR THE ACRYLIC-1
PAINT to achieve the proper consistency when
using spray equipment. Thinning increases drying
time by two or three fold but assures “wetting
out” of the ACRYLIC-1 paint offering optimum
electrical properties. Thinner should never exceed
25% by volume. The POLYURETHANE coatings
can be used with spray equipment as supplied. It
is not recommended to thin the POLYURETHANE
COATINGS. Toluene can be used for solvent
cleaning the ACRYLIC-1.
ORDERING INFORMATION
Small quantities can be shipped within one week
after receipt of order. To order TECKNIT conduc-
tive paint, specify quantity and par
t number
. For
additional assistance, or for scheduling large
quantity shipments, contact your nearest TECK-
NIT ar
ea r
epr
esentative or factor
y location.
G-15
U.S. Customary
[SI Metric]