• Housing lances
• Retainer
•
Suited for large current
• Compatible for both wire-to-wire and wire-to-
board connections
This VL connector is 6.2 mm pitch wire-to-
wire and wire-to-board connector, designed
for large current. The connector suitable for
the large electric current has been realized
by using highly-conducting material, so that
the connection of large current circuit
enables.
1
<4 circuits>
Outer-housing lock
Specifications –––––––––––––––––––
• Current rating: 23 A AC, DC (Refer to the following table.)
• Voltage rating: 600 V AC, DC
• Temperature range: -25˚C to +90˚C
(including temperature rise in applying
electrical current)
• Contact resistance: Initial value/ 7 mΩ max.
After environmental tests/ 10 mΩ max.
• Insulation resistance: 1,000 MΩ min.
• Withstanding voltage: 2,000 VAC/minute
• Applicable wire: AWG #20 to #12
• Applicable PC board thickness: 1.6 mm
Note:
Do not branch in parallel current which exceeds the rated current (e.g. more than
22 A in the case of 3 circuits with AWG #12). If branched in parallel, current
imbalance or other problems may develop. If it is absolutely necessary to branch
such a large current in parallel, design the circuits without causing any imbalance
and provide an extra margin for each circuit.
Note: The current rating differs depending on the number of circuits and the wire
size used in each connector. The table below lists the current rating as a
function of the number of circuits and the wire size.
* The current rating mentioned above is applied only in the combination of
contact and header for high current. When either is a normal product, please be
careful because the current rating of the normal product is applied.
* In using the products, refer to "Handling Precaution for Terminal
and Connector" described on our website (Technical documents
of Product information page).
* Contact JST for details.
* RoHS2 compliance
Standards ––––––––––––––––––––––
0 Recognized E60389
1
Certified LR20812
2
R9351103
PC board layout and Assembly layout
<2, 3, 4 (Single-row) circuits>
Note: 1. The above figure is the figure viewed from soldering side.
2. Tolerances are non-cumulative: ±0.05 mm for all centers.
3. Hole dimensions differ according to the type of PC board and piercing method. The dimensions above should serve as a guideline. Contact JST for details.