02 | Keysight | E7515A UXM Wireless Test Set - Data Sheet
www.keysight.com/find/uxm
Make a Clear Call
The team looks to you: will a new chipset or UE pass the crucial tests? Clarity comes
from accumulated insights – insights enabled by the Keysight Technologies’s UXM
wireless test set. The UXM is a highly integrated signaling test set created for functional
and RF design validation in the 4G era and beyond. It provides the capabilities you need
to test the newest designs, delivering LTE-Advanced data rates up to 1 Gbps now and
handling more complex requirements later. When the team counts on you, count on the
UXM to help you assess design readiness with greater confidence and make a clear call.
Definitions and Conditions
The specifications in this document apply to single TRX instruments with serial number
MY5520xxxx/TH5520xxxx and dual TRX instruments with serial number MY5521xxxx/
TH5521xxxx.
The test set will meet its specifications when
– The test set is within its calibration cycle
– The test set has been stored at an ambient temperature within the allowed operating
range for at least two hours before being turned on; if it had previously been stored
at a temperature range inside the allowed storage range, but outside the allowed
operating range
– The test set has been turned on for at least 30 minutes
Specification
Specifications describe the performance parameters covered by the product warranty
and are valid from 20 to 35°C unless otherwise noted.
Typical
Typical describes additional product performance information that is not covered by the
product warranty. It is performance beyond specifications that 95 percent of the units
exhibit with a 95 percent confidence level. This data, shown in italics, does not include
measurement uncertainty, and is valid only at room temperature (23°C).
Nominal
Nominal values indicate expected performance, or describe product performance that is
useful in the application of the product, but are not covered by the product warranty.