SMBJ SERIES
Revision:21-Jul-14 www.brightking.com
Transient Voltage Suppressors (TVS) Data Sheet
Features
■ For surface mounted applications in order to optimize board space
■ Low profile package
■ Built-in strain relief
■ Glass passivated junction
■ Low inductance
■ Excellent clamping capability
■ 600W peak pulse power capability at 10/1000μs waveform,
repetition rate (duty cycle): 0.01%
■ Fast response time
■ Typical I
R
less than 1μA above 10V
■ High Temperature soldering: 260 /℃ 10 seconds at terminals
■ Plastic package has underwriters laboratory flammability 94V-0
■ Meets MSL level 1, per J-STD-020
■ Safety certification: UL: E244458
Mechanical Data
■ Case: JEDEC DO-214AA. Molded plastic over glass passivated junction
■ Terminal: Solder plated, solderable per MIL-STD-750, Method 2026
■ Polarity: Color band denotes cathode except bi-directional models
■ Standard Packaging: 12mm tape (EIA STD RS-481)
■ Weight: 0.10g
Applications
■ I/O interface ■ AC/DC power supply
■ Low frequency signal transmission line (RS232, RS485, etc.)
Maximum Ratings and Characteristics
Ratings at 25℃ ambient temperature unless otherwise specified.
Rating Symbol Value Units
Peak pulse power dissipation at 10/1000μs waveform
(Note1, Note2, Fig.1)
P
PPM
Minimum 600 Watts
Peak pulse current of at 10/1000μs waveform (Note 1, Fig.3) I
PPM
See Table Amps
Steady state power dissipation at T
A
=50℃ (Fig.5) P
M(AV)
5.0 Watts
Peak forward surge current, 8.3ms single half sine-wave
superimposed on rated load, (JEDEC Method) (Note3, Fig.6)
I
FSM
100 Amps
Operating junction and Storage Temperature Range. T
J
,T
STG
-65 to +150 ℃
Typical thermal resistance junction to lead R
θJL
20 ℃/W
Typical thermal resistance junction to ambient R
θJA
100 ℃/W
Notes: 1. Non-repetitive current pulse, per Fig.3 and derated above T
A
=25℃ per Fig.2.
2. Mounted on 5.0mm×5.0mm (0.03mm thick) copper pads to each terminal.
3. 8.3ms single half sine-wave, or equivalent square wave, duty cycle=4 pulses per minutes maximum.