Reproduction in whole or in part is prohibited without the prior written permission of the copyright holder.

November 2008

nRF24LU1

Single Chip 2.4GHz Transceiver with USB

Microcontroller and Flash Memory

Product Specification v1.1

Key Features

• nRF24L01 compatible RF transceiver

• Worldwide 2.4GHz ISM band operation

• Up to 2Mbps on air data rate

• Enhanced ShockBurst™ hardware link layer

• Air compatible with nRF24L01, nRF2401A, 02,

E1 and E2

• Low cost external ±60ppm 16MHz crystal

• Full speed USB 2.0 compliant device controller

• Up to 12 Mbps USB transfer rate

• 2 control, 10 bulk/interrupt and 2 ISO endpoints

• Dedicated 512 bytes endpoint buffer RAM

• Software controlled pull-up resistor for D+

• PLL for full-speed USB operation

• Voltage regulator, 4.0 to 5.25V supply range

• Enhanced 8-bit 8051 compatible

microcontroller

• Reduced instruction cycle time

• 32-bit multiplication-division unit

• 16 kbytes of on-chip flash memory

• 2 kbytes of on-chip SRAM

• 6 general purpose digital input/output pins

• Hardware SPI slave and master, UART

• 3 16-bit timers/counters

• AES encryption/decryption co-processor

• Supports firmware upgrade over USB

• Supports FS2 hardware debugger

• Compact 32-pin 5x5mm QFN package

Applications

• Compact USB dongles for wireless

peripherals

• USB dongles for mouse, keyboards and

remotes

• USB dongle 3-in-1 desktop bundles

• USB dongle for advanced media center

remote controls

• USB dongle for game controllers

•Toys

Revision 1.1 Page 2 of 173

nRF24LU1 Product Specification

Liability disclaimer

Nordic Semiconductor ASA reserves the right to make changes without further notice to the product to

improve reliability, function or design. Nordic Semiconductor ASA does not assume any liability arising out

of the application or use of any product or circuits described herein.

All application information is advisory and does not form part of the specification.

Limiting values

Stress above one or more of the limiting values may cause permanent damage to the device. These are

stress ratings only and operation of the device at these or at any other conditions above those given in the

specifications are not implied. Exposure to limiting values for extended periods may affect device reliability.

Life support applications

These products are not designed for use in life support appliances, devices, or systems where malfunction

of these products can reasonably be expected to result in personal injury. Nordic Semiconductor ASA cus-

tomers using or selling these products for use in such applications do so at their own risk and agree to fully

indemnify Nordic Semiconductor ASA for any damages resulting from such improper use or sale.

Contact details

For your nearest dealer, please see www.nordicsemi.no

Main office:

Otto Nielsens vei 12

7004 Trondheim

Phone: +47 72 89 89 00

Fax: +47 72 89 89 89

www.nordicsemi.no

Data sheet status

Objective product specification This product specification contains target specifications for product

development.

Preliminary product specification This product specification contains preliminary data; supplementary

data may be published from Nordic Semiconductor ASA later.

Product specification This product specification contains final product specifications. Nordic

Semiconductor ASA reserves the right to make changes at any time

without notice in order to improve design and supply the best possible

product.